User manual SUNBEAM GCSBBV-102

[. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. [. . . ] Always disconnect iron from electrical outlet when filling with water, cleaning or emptying and when not in use. The Fabric Select Dial and Steam Lever should always be turned to OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. To protect against risk of electric shock, do not immerse the iron in water or other liquids. When using electrical appliances, basic safety precautions should always be followed including the following: Fill water cup with tap water and pour water into iron water reservoir. WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. CAUTION: The STORAGE STRIPTM indicator should only be used as a guideline. TURNING OFF YOUR IRON: Turn the Steam Dial to (Dry) and Fabric Select Dial to Off and unplug the iron from the power source. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. NOTE: While the Steam Dial is turned to the (Dry) setting, you may still use the SHOT OF STEAM® or SPRAY MIST® feature, as long as the Fabric Select Dial is set to wool, cotton, or linen. If you do not use your iron on a daily basis, empty the water reservoir after each use for a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole cover, and allow water to flow from the fill hole. Loosely loop the power cord around the heel rest and store the iron on its heel rest. IMPORTANT: Wrapping the cord around the iron too tightly can damage the cord. TO CLEAN THE SOLEPLATE: allow the iron to cool and then wipe it with a soft, damp cloth. WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the soleplate. [. . . ] The Power Indicator will blink to let you know that the iron has stopped heating. iMPORTANT: The Power Indicator will continue to blink until the iron is unplugged or reset. TO RESET THE IRON: Move the iron back and forth and allow it to reheat for 2 minutes. [. . . ]