User manual SUNBEAM GCSBHH01-033

[. . . ] The use of accessory attachments not recommended by Sunbeam Products, Inc. To reduce the risk of electrical shock, this appliance has a polarized plug (one blade is wider than the other). This plug fits a polarized outlet only one way; if the plug does not fit fully into the outlet, reverse the plug. Use Caution when you turn garment steamer upside down ­ there may be hot water in the reservoir. [. . . ] A jet of steam can then be produced about every 3 seconds by pressing the steam button. Apply steam from around 80mm distance from the fabricand then start brush cleaning NOTE: When the steamer is plugged in, slight steam may come out even if the steam button is not pressed. Water Level Indicator: The water level indicator shows at any time whether there is sufficient water in the tank. To check the reservoir level, hold garment steamer so that the water window is vertical. The body and front panel (when cool) should occasionally be wiped with a moist cloth. Storage The appliance may be stored by means of the hanging loop or placed on a clean, dry shelf. Emptying the Water Tank Remove the plug from the electrical outlet and allow the appliance to cool down. If you do not intend to use the appliance again soon, it is advisable to drain the water from the tank. Removal of Lint and Fluff Lint, threads, fluff and hair can easily be removed with the lint brush. Replace by inserting small tab in the slot at the top or bottom of the cavity. Care of Curtains and Upholstery Creases can be removed from curtains while they are hanging on the rod; simply follow the procedure described in "Care of Clothes". The appearance of upholstery can also be improved by steaming with the appliance. If the appliance is being used in a horizontal position, best results are achieved by holding it upright occasionally. Care of Clothes Hang the creased article of clothing on a clothes hanger. Pull the clothing lightly with one hand, place the appliance over the creased area. Gently press the appliance against the clothing, and press and release the Shot of Steam® button about every 2 seconds as described above. In this way, steam will penetrate right into the fabric, and not just pass over the surface. When doing so, press the Shot of Steam® button as described and at the same time smooth the material with the clothes brush. All repairs must be made by SUNBEAM or by an Authorized Sunbeam Service Center. Doing business as Jarden Consumer Solutions or if in Canada, Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions (collectively "JCS") warrants that for a period of one year from the date of purchase, this product will be free from defects in material and workmanship. [. . . ] This warranty gives you specific legal rights, and you may also have other rights that vary from province to province, state to state or jurisdiction to jurisdiction. If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800-334-0759 and a convenient service center address will be provided to you. In Canada If you have any question regarding this warranty or would like to obtain warranty service, please call 1 800-667-8623 and a convenient service center address will be provided to you. In Canada, this warranty is offered by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, located at 20B Hereford Street, Brampton, Ontario L6Y 0M1. [. . . ]