User manual SUNBEAM STEAM MASTER IRONS

[. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. [. . . ] Do not set the iron on an unprotected surface, even if it is on its heel rest. Fill water cup with tap water and pour water into iron water reservoir. WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. Note: While the Steam Lever is turned to the (Dry) setting, you may still use the SHOT OF STEAM® or SPRAY MIST® feature, as long as the Fabric Select Dial is set to wool, cotton, or linen. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. IMPORTANT: When not ironing, always set the Steam Lever to (Dry) and the Fabric Select Dial to OFF. You can use this feature while Dry or Steam ironing, as long as the Fabric Select Dial is set to wool, cotton, or linen. TO USE THE SHOT OF STEAM® FEATURE: Place the iron on top of the wrinkle and press the Shot of Steam® button each time you would like an extra burst of steam. The Shot of Steam ® feature may be used continuously in approximately 3-second intervals. vERTICAL STEAM (select models only) allows your iron to function as a garment steamer. Tip: When using vertical steam on clothing, hang the clothing on a clothes hanger for best results. Hold the iron in a vertical position, with the iron close to but not touching the fabric you want to steam. Press the Shot of Steam® button in approximately 3-second intervals as you move the iron across the wrinkled area. WARNING: To prevent the risk of burns, keep your hand away from the area being steamed. WARNING: DO NOT steam garments while wearing them; this may result in injuries. Once the Auto-Off activates, the power indicator light will turn off and the iron stops heating. tO RESTART THE IRON: Press the Restart Button (Power Indicator Light). then move the Variable Steam Lever to (Dry) and the Fabric Select Slider to Off. WARNING: The Auto-Off is a safety feature and is not a recommended means for turning your iron off. " MOTION SMART AUTO-OFF FEATURE (select models only) When the iron is plugged in, the Power Indicator will light steadily, indicating that there is power to the iron. In a horizontal position without moving it, or accidentally tip the iron over, it will automatically stop heating after 30 seconds. [. . . ] IMPORTANT: Wrapping the cord around the iron too tightly can damage the cord. CLEAN THE SOLEPLATE: allow the iron to cool and then wipe it with a soft, damp cloth. WARNING: DO NOT use abrasive cleansers, scouring pads or vinegar to clean the soleplate. USING THE SELF-CLEANING FEATURE: You should use the Self-Cleaning feature once a month to maintain the optimal performance of your iron. [. . . ]