User manual T-FAL CM4000

[. . . ] ⷠBefore plugging in the appliance, check that the voltage shown on the appliance matches your electrical system's voltage, and check that the wall socket is earthed. ⷠUnplug the appliance as soon as you have finished using it and when you clean it. ⷠDo not use the appliance if it is not working properly or if it has been damaged. [. . . ] The first time you use your new coffee maker, run the appliance once with 1 litre of water but no coffee, to flush the water circuit. ⷠDo not exceed the maximum water level shown on the tank's water level gauge. ⷠClose the lid (a) while the coffee maker is operating. ⷠThis coffee maker is fitted with a drip-stop device, allowing you to serve coffee before the water has finished percolating. ⷠYou can reheat coffee by placing the jug (depending on model) in the microwave. on models equipped with a permanent filter: O · Place ground coffee directly into the permanent filter . Dispose of the coffee grounds after use and rinse the filter under the tap. Some models are equipped with a jug with a Thermocontrol indicator: · This device indicates whether the coffee inside the jug is at a suitable temperature for drinking. Some models are supplied with an insulated flask: · To keep your coffee warm for longer, rinse the insulated flask with hot water before use. ⷠAlways screw down the lid fully (by turning it clockwise) when making coffee and keeping it warm. S PROGRAMMING YOUR COFFEE MAKER (depending on model) When you switch the coffee maker on, the time display flashes and reads ; the cup and clock symbols are on steady. Set the hours by pressing the button repeatedly, or hold it down to cycle continuously through the hours . Set the minutes by pressing the button repeatedly, or hold it down to cycle continuously through the minutes . The clock symbol disappears (if you do not confirm by pressing this button within 30 seconds, the appliance cancels the changes and reverts to the existing time). Operating the coffee maker manually cancels any automatic start that may have been programmed. Programming the coffee maker to start automatically (not possible until the clock has been set): · press the button once . Set the hours by pressing the button repeatedly, or hold it down to cycle continuously through the hours . Set the minutes by pressing the button repeatedly, or hold it down to cycle continuously through the minutes . [. . . ] The warranty does not cover coffee makers that malfunction or cease to operate because they have not been regularly descaled. S ACCESSORIES Accessories are available from any good specialist store. - If the water percolates too slowly or there is excessive noise: · descale your coffee maker. [. . . ]