User manual T-FAL CM425D10

[. . . ] Do not immerse the appliance, power cord or plug in water or any other liquid. The power cord must never be close to or in contact with the hot parts of your appliance, near a source of heat or over a sharp edge. For your safety, only use the manufacturer's accessories and spare parts designed for your appliance. These include actual usage tests on randomly selected appliances, which would explain any traces of use. [. . . ] Turn the selector (h) to the right to the position to obtain a normal coffee, where the entire amount of water contained in the tank passes through the coffee grounds. To obtain a very weak coffee, position the selector (h) to the left to the position . Only about half of the amount of water contained in the tank passes through the coffee grounds. 1-4 cups indicator: The icon will display when you push on the "1-4 cups" button but will not start the brewing. ON indicator: The icon will display when you push ON the "On-Off" button (red light "R"). To set the hour, press the "H" button once, HOUR will increase from the initial 0:00 at one-hour intervals. Pressing and Holding the "H" button for more than 2 seconds will make the HOUR advance at a rate of about 3-5 hours per second. To set minute, press the "min" button once, MINUTE will increase from the initial 0 at one-minute intervals. Pressing and Holding the "min" button for more than 2 seconds will make the MINUTE advance at a rate of about 3-5 minutes per second. The icon indicated on the LCD: red light "R" will become activated, and brewing cycle starts. To deactivate the brewing cycle manually: The "On/Off" button is pressed, the logo shut off: the red light will be deactivated and the heater will turn off, and brewing process will stop. The icon will be indicated on the LCD and Program-on function (green light "R") will become activated. At programmed time, the icon shuts off and the icon indicated on the LCD (red light "R" becomes activated). To disable the "Program-on" function: Press the "Auto-On" button and icon will shut off and the green light "R" will be deactivated. Set" button once then LCD starts flashing with the Program-on time and the coffee maker enters in Program-on time setting mode (Prog Set mode). To set hour, press the "H" button once, HOUR will increase from the initial 12:00 at one-hour intervals. Pressing and Holding the "H" button for more than 2 seconds will make the HOUR advance at a rate of about 3-5 hours per second. To set minute, press the "min" button once, MINUTE will increase from the initial 0 at one-minute intervals. [. . . ] Switch the coffee maker back on to run the rest of the liquid through. Rinse the coffee maker by running 1 litre of water through it 2 or 3 times. The guarantee does not cover coffee makers that do not work properly or do not work at all because they have not been descaled. - If the water flow-through time is too long or makes too much noise descale your coffee maker. [. . . ]