User manual TANDBERG SUPERLOADER DLT MAGAZINE QUICK START GUIDE

[. . . ] SuperLoaderTM Magazine Quick Start Guide For more information about Tandberg Data's quality products, visit www. tandberg. com Tandberg Data publications can be requested from a Tandberg Data Sales Representative or ordered directly from Tandberg Data. For the latest information about Super DLTtapeTM and DLTtapeTM products and accessories, visit the Tandberg Data web site at www. tandberg. com or the Technical Support site at www. dlttape. com. [. . . ] c On the Eject submenu, scroll to Right Magazine or Left Magazine, depending on which magazine you want to eject and press Enter. The magazine pops forward so that the front of the magazine is no longer flush with the front panel. d With one hand, grasp the magazine by the handle and slide it forward to remove. Place your other hand under the magazine to support it and prevent it from falling. a Place the carton on an ESD-safe work surface. b Use a utility knife or scissors to cut the packing tape along the length and ends of the carton. f Place the magazine on a flat surface and rotate the assembly using the manual indexing wheel. g When the carrier assemblies rotate freely, the magazine is ready for use. a On the front panel, scroll to Commands and press Enter. b On the Commands submenu, scroll to Eject and press Enter. For additional information: Refer to the enclosed CD-ROM, or visit www. tandberg. com 2 Support here. Grasp here. 3 3 Section 3 explains how to reinstall a magazine. Reinstall a magazine 4 a Remove/reinstall a magazine blank To remove a magazine blank, pull the magazine straight out. a Grasp the magazine by the handle with one hand and support it underneath with the other hand. Make sure that you position the magazine correctly; it should slide smoothly. Caution Insert the magazine slowly to avoid damaging internal components or autoloader. [. . . ] (Procedure continues. ) 8 9 Change the orientation, continued c Rotate the handle 180 degrees so that what was the top of the handle is now the bottom. Right magazine handle Left magazine handle d Snap the handle back on the front of the magazine blank. e Install the two screws to attach the handle securely to the magazine blank. 10 11 [. . . ]