User manual THERMA DH CAMINO SE1

[. . . ] In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. bottom connections. To do use the two 8mm diameter screws and plugs supplied as standard equipment. -- Take the measure between the ceiling and the hood top, and adjust the duct to this height. [. . . ] The hood has a microswitch so that once the motor speed has been selected and the light switched on, the hood can be started by simply pulling out the control panel. The control panel can be positioned at the desired angle to light the cooking area. Fastening the hood to the wall Filter version with internal recycling The air is filtered through a carbon filter and recirculated into the room through the grating. This version is used when there is no exhaust duct for venting outdoors or when it is impossible to install one. To use the hood in this version, proceed as follows: -- If no filter is supplied with the hood, ask the technical assistance service or the manufacturing company for one and specify the hood model. -- To install the filter, fit it in the seat at the front and fasten it at the back with the two hooks B (Fig. 4) -- Position the template in the correct position and make two 8mm diameter holes and two 12mm diameter holes. -- Secure it in place with the two 5x45 mm screws and 5-20 mm diameter washers in the top holes. The screws and washers are standard equipment. MAINTENANCE Before performing any maintenance operation, disconnect the hood from the electricity. Grease filter This serves to hold the grease particles in suspension. To remove the filter, push it towards the back of the hood and pull it downwards (Fig. Clean it at least once a month. INSTALLATION When installed, the hood must be not less Installing the duct for venting to outside (exhaust version) (Fig. 5-6) -- Fasten the top support E to the wall close to the ceiling on the perpendicular of the 10 11 Carbon filter This filter dissolves cooking odours. Ask the technical assistance service or manufacturing company for a new one. To remove the carbon filter, push the pushbuttons B inwards and pull the filter downwards (Fig. 2). I DESCRIZIONE DELLA CAPPA 1) Tasto velocità motore 2) Tasto luce 3) Spia di funzionamento 4) Griglia d'aspirazione 5) Illuminazione piano di lavoro INSTALLAZIONE (Fig. [. . . ] -- Per montare il filtro, inserirlo nell'apposita sede anteriore e fissarlo posteriormente con i due agganci B (Fig. Chiudere le serrandine P prima di utilizzare la cappa in questa versione (Fig. 4) -- Posizionare la dima nella giusta posizione ed eseguire 2 fori Ø 8 mm e 2 fori Ø 12 mm. [. . . ]