User manual THOMSON ASR08T

[. . . ] (Switch it off, unplug the mains lead, and consult your dealer. ) Never open your set, because this could expose you to dangerous voltages. Above all Do not allow anyone (children in particular) to insert any object in the holes, slots, or other openings in the housing. The identification label is located under the set. ENGLISH 3 CONTENTS Page REMOTE CONTROL UNIT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The video recorder images will be transmitted to the TV through the TV SCART connector if the video recorder supplies the control voltage when it is in read mode (12V on pin 8 of the VCR SCART connector ). Connection to a decoder Using a SCART cable (not supplied), connect the Socket receiver to the SCART socket of your decoder. Connection to a stereo system : Your satellite receiver can be connected to a stereo system using the CINCH connectors . 8 EVERYDAY USE On/Standby Using set keypad: Press the On/Standby key. Using remote control: Switch the receiver on by pressing one of the numeric keys (0 to 9), or on the remote control keypad. If the set is switched on using the or keys, the last programme number active before switching off is called up, for example : " 13". The display shows : " -" Programme Selection Using set keypad: Press the programme scrolling keys Using remote control: a) Direct selection using numeric keys 0 to 9, or b) Channel scrolling using the or . a) Direct selection: For the first ten programmes, press the corresponding key briefly. For two- or three-digit programme numbers, the number must be entered in three seconds. For example, to select Programme 14: - Briefly press the 1 key " -1" appears on the display. Examples: Enter 1 Display : -1 Programme 1 appears on screen Enter 24 Display : -24 Programme 24 appears on screen Enter 399 Display : 399 Programme 399 appears on screen b) Channel scrolling using the or keys. Volume Adjustment You can adjust the receiver volume using the VOL + (louder) and VOL - (softer) keys. The last setting in use is stored in memory when the receiver is placed on Standby. ENGLISH 9 RECORDING SATELLITE PROGRAMMES If your receiver is connected to a VCR, you can record satellite programmes. Paragraph 2 : Connection to a VCR in the INSTALLATION OF SATELLITE RECEIVER chapter of the present manual describes the procedure for connecting the VCR to the receiver. Refer also to your VCR user manual. ENGLISH On your satellite receiver, select the channel you wish to record, then, on the VCR, select the programme number assigned to the satellite receiver (e. g. To avoid recording a different programme or nothing at all, do not change satellite channel or switch off the receiver before recording is complete. If you wish to record a satellite programme during your absence, select the desired channel on the receiver, and programme the recording start and stop times on your VCR. [. . . ] Press the key (the display shows : "----") then use the numeric keypad to enter one of the codes shown below. Then confirm the code by pressing again. PL PL PL key - enter code 6725 key - enter code 6726 - PL key - programme locked. key - receiver locked. PL PL Repeat the procedure to deactivate the lock. [. . . ]