User manual THOMSON DPL950VD-RECEIVER

[. . . ] DPL950-EN receiver new 5/7/03 10:35 AM Page 1 Safety Information Thomson Information CAUTION! Invisible laser radiation when open. This system must be opened only by qualified technicians to prevent accidents caused by the laser beam. LASER = 780 nm, P max = 5 mW Rating Information: At bottom of the unit this unit comply with the existing requirements In accordance with the rating plate of the unit, this unit complies with current standards concerning electrical safety and electromagnetic compatibility. Please respect the environment Before throwing any batteries away, consult your distributor who may be able to take them back for specific recycling. [. . . ] "DTS" and "DTS Digital Surround" are registered trademarks of Digital Theater Systems, Inc. All Rights Reserved. Dolby Digital Manufactured under license from Dolby Laboratories. "Dolby", "Pro Logic", "Pro Logic II" and the double-D symbol are trademarks of Dolby Laboratories. All Rights Reserved. NOTE All preset radio stations and surround sound setting will be lost after factory setting is restored. 9 DPL950-EN receiver new 5/7/03 10:35 AM Page 14 Operating Your Receiver 1 6 2 7 8 13 4 5 11 9 10 BAND/APP SOURCE BASS/TREBLE RPT/PROG. VOLUME RANDOM SURROUND PRESET - PRESET + POWER/ECO PHONES 3 15 14 12 Receiver Controls 1. POWER / ECO · To turn the unit on (set the POWER/ECO swtich to the ON position) / off. (set the POWER/ECO swtich to the OFF position) When the system is turned on, the unit will go to Standby mode (red led will lit), then press the SOURCE button on the unit to power the unit up in the last mode used. · When the unit is in standby mode, press the Source button to power on the unit. SURROUND · Press repeatedly to select the surround sound setting or Digital Sound Processor (DSP) mode you want. PRESET - / SKIP REVERSE · To move back to the beginning/previous preset memory location in tuner mode. · To skip to the beginning/previous track in CD mode and the beginning/previous chapter in DVD mode (only while playing). PRESET + / SKIP FORWARD · To go to the next preset memory location in tuner mode. · To skip to the next track in CD mode and the next chapter in DVD mode (only while playing). BAND / APP / RANDOM · In Tuner mode, press to select between radio BANDS or press and hold to enter AUTO PROGRAM mode. BASS / TREBLE / TV OUTPUT · To adjust BASS / TREBLE, press this button once to choose either bass or treble, then press preset + and preset - to adjust level. (Bass/ treble adjustment is not allowed for DTS source) · Press and hold to swtich TV output mode (RGB SCART / SVideo), default is RGB SCART. 8. REPEAT (RPT) / PROGRAM (PROG) · Press to choose different play mode in DVD/CD playback. PHONES Plug your headphones (not supplied) into it for your private enjoyment. · When in protection mode, the blue led will blink continuously, · During panel up/down and power up, the led will blink for a few seconds. 10 DPL950-EN receiver new 5/7/03 10:35 AM Page 15 Operating Your Receiver Your Remote Control Please be sure you have inserted the batteries into the remote control (see relevant section on page 3. ) · stereo - Selects stereo mode Subtitle - Press to turn subtitles on/off. · theater modes - Selects among theater modes (DOLBY PL II MOVIE, DOLBY PL II MUSIC, DOLBY PRO LOGIC EMULATION, 3 STEREO, ARENA, JAZZ CLUB, THEATER, STADIUM, DISCO, STEREO) info - shows on-screen banner. · delay - In HiFi mode, press to select speaker delay settings (between speakers and your favorite listening position). Press repeatedly and the display will toggle among different channels (Left front speaker, Right front speaker, Center speaker, Left rear speaker, Right rear speaker and Subwoofer). Press the left and right arrow buttons beside OK button for adjustment angle - selects different screen display angles if available. [. . . ] (Not available in Dolby Digital and DTS) Default Settings The receiver will keep the last selection in memory as long as it doesn't enter standby mode. Night Mode By using Dynamic Range Compression technology, you can enjoy enhanced Dolby Digital sound quality at night without interrupting your roommates or neighbors. Night Mode will compress the difference in volume between normal voices and sound like explosions, while still enjoying a Dolby Digital enable component (DVD, SAT). Night Mode can be activated by press and hold the OK button, DRC SOFT (Default) will appear on the display. While DRC SOFT (Default) is still on the display, press the LEFT or RIGHT adjustment buttons, around the OK button, until you select the desired mode. [. . . ]