User manual THOMSON ROC 240

[. . . ] Direct the remote control towards the TV set and try to switch it off by simply pressing the key B (1). Should the set not switch off, you'll have to programme the remote control by means of one of the methods A, B, C or D described hereinafter in chapter 3. [. . . ] Direct the remote control towards the set and try to switch it off by pressing the key B (1). Check of the programming In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the key SHIFT (4) until the red indicator lamp (11) remains lit. Direct the remote control towards the set and try to switch it off by pressing the key B (1). Should the set not switch off, press key B (1) as many times as required (up to 200 times), until the set switches off. Between two subsequent key depressions, give the red indicator lamp (11) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming In principle, your set is ready for receiving the remote control commands. Perform the following tests to check proper functioning: - For a TV set or satellite receiver: press for instance number key 2 to switch over to another channel or to switch the set on, in case it is off. Try out other remote control keys to find out the range of functions you can control. [. . . ] To travel through the setting menus, press the SHIFT key once and then use the keys up, down, left and right (16 and 17). You can contact THOMSON by dialing: 0845 601 3093, from 27 November 2000. [. . . ]