User manual THOMSON ROC 250

[. . . ] The MODE+ key allows you to programme and control all kinds of sets such as TVs, satellite receivers, video recorders, DVD players and so on). Press this key first, before you type in the 2-digit channel number (except for Thomson group equipment). Press the key (16) that corresponds to the type of equipment you want to control: TV: television set MODE+: other set 3. Direct the remote control towards the TV set and try to switch it off by simply pressing the key B (18). [. . . ] Hold down the key S (7) until the red indicator lamp (4) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key (16) that corresponds to the type of equipment you want to control: TV: television set, MODE+: other set 4. Direct the remote control towards the set and try to switch it off by pressing the key B (18). If the set you want to control switches off, press OK (2) to memorise the subcode. Should the set not switch off, press key B (18) as many times as required (up to 200 times), until the set switches off. Between two subsequent key depressions, give the red indicator lamp (4) enough time to extinguish and light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Note: When programming the MODE+ key, begin by entering a code corresponding to the set you want to programme (a 3-digit code that you will find in the code booklet, see method B). Example: if you want to control a satellite receiver with the MODE+ key, begin by entering a satellite code (any satellite code that you find in the code list, for example: 603 for a Thomson satellite receiver) then begin the automatic search procedure. the remote control will then test all the satellite codes for the selected make. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 4. With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold down the key S (7) until the red indicator lamp (4) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). Press the key corresponding to the type of equipment (for example TV). After a few seconds, the remote control begins to scroll through the whole code list included in the library (at a rate of roughly 1 code per second). Press the PR + key once again to slow down the test speed (1 code every 3 seconds). As soon as the set changes channels, you must press OK (2) to save the code and stop the remote control scrolling through the list. [. . . ] Hold down the key S (7) until the red indicator lamp (4) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes to signal that this time is almost up, and then goes off). The indicator light will blink and then go off for about 8 seconds before blinking once more and then staying off. If the remote control previously controlled the television volume in SAT (MODE+) mode, it will now control the volume of the satellite receiver; if it previously controlled the volume of the satellite receiver, it will now control the television volume. [. . . ]