User manual THOMSON ROC 3205

[. . . ] Press this key first before you type in the 2-digit channel number (except for Thomson group products). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, DVD: DVD player, SAT: satellite receiver. Point the remote control towards the product and try to turn it off by pressing the POWER (12) key. [. . . ] Point the remote control towards the product and try to turn it off by pressing the POWER (12) key. If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list. Checking the programming: Your product should be ready to receive remote control commands. Check to see that your remote functions correctly by performing the test described on page 3. Method C - Programming by means of code retrieval If none of the codes work, you may still be able to retrieve the appropriate code. Hold down the SETUP (11) key until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). Press the product key (2) that corresponds to the type of product you want to control: TV: television set, DVD: DVD player, SAT: satellite receiver. Point the remote control towards the product and try to turn it off by pressing the POWER (12) key. If the appliance to be controlled switches off, press the MUTE (15) key to memorise the code. If the product does not turn off, press the POWER (12) key until the product switches off (up to 200 times). Wait approximately one second between key presses to give the red indicator lamp (1) enough time to go off and light up again. This will allow you to see whether the product responds or not. Immediately upon turning off the product to be controlled, press the MUTE (15) key to save the code. Note: If you want to assign another type of product than those mentioned on the remote control, begin by entering a code that corresponds to the product you want to programme (a 3-digit code that you will find in the code booklet ­ see method B). Example: if you want to control a satellite receiver with the DVD key, begin by entering a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then begin the procedure. Checking the programming: Your product should be ready to receive remote control commands. Check to see that your remote functions correctly by performing the test described on page 3. Method D - Automatic code search With this method, the remote scrolls through the full code list by sending an IR signal to the product to be controlled remotely. Hold down the SETUP (11) key until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. [. . . ] If the remote previously controlled the television volume in SAT mode, it will now control the volume of the satellite receiver; if it previously controlled the volume of the satellite receiver, it will now control the television volume. 4 - How to retrieve a programmed code You may want to retrieve the code programmed in the remote control. Hold down the SETUP (11) key until the red indicator lamp (1) remains lit (the indicator light remains on for a few seconds to give you the time to proceed with the following steps. The indicator lamp flashes when this time is almost up, and then goes off). [. . . ]