User manual THOMSON ROC 36

[. . . ] It can replace 6 remote controls thanks to its 6 mode keys TV, DVD, VCR, . It is compatible with the majority of television sets, video cassette recorders, DVD players, satellite and cable receivers as well as terrestrial digital television (DVBT), amplifiers and other audio equipment provided they are controlled by infra red signals. It has 4 additional function keys (L1 to L4) that can be used as additional device keys. It incorporates a home cinema mode that transforms your installation by bringing together virtually all devices and considering them as a single device, each part of the remote control then controls parts of this ensemble. [. . . ] Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit (the indicator lamp remains lit for several seconds in order to let you continue with the following steps. The blinking of the indicator indicates the end of the available time, then it goes out). In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 3. Try out other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit. Press the key that corresponds to the type of equipment you want to control: TV: television set - DVD: DVD player - VCR: video cassette recorder - SAT: satellite - CBL: cable - AUDIO: Hifi system - AUX: other devices. With this method, the remote control scrolls through the full code list by sending an IR signal to the set to be controlled remotely. Hold the SETUP key down until the key corresponding to the last selected mode blinks and then remains lit (the indicator lamp remains lit for several seconds in order to let you continue with the following steps. The blinking of the indicator indicates the end of the available time, then it goes out). This leaves little time for reading the instructions and then carrying them out. If the mode indicator light blinks and then goes out, it is because this time limit has been exceeded, you must start again from step 1. If the make of the device you wish to control is not in the separate code list, you can copy the key functions of the original remote control of the device into your ROC 36. Depending on the format of the transmission codes of the original remote control, your ROC 36 remote control can memorise up to 150 keys Press and hold down the SETUP key until the mode key blinks (TV, VCR, . Press once the A, B, or C key which you are going to use to memorise the sequence. ) mode key of the first device you wish to control (the first key must always be a mode key. Successively press the keys corresponding to the commands you wish to send to the device(s) (9 keys maximum, including other mode keys). Note: a sequence will be automatically memorised after the tenth key press (counted from the mode key) and the mode key light will go out. Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) 1. Hold down the SETUP key until the key corresponding to the last selected mode remains lit. The batteries in the 2 remote controls must be in good condition; change them if necessary. [. . . ] Hold down the SETUP key until the key corresponding to the last selected mode remains lit. (4) keys then once Press once on the VOL or on the mode key (TV, DVD, VCR, . Press once on one of these keys (8) then once on the mode key (TV, DVD, VCR, . Press once on one of the navigation keys (5) then once on a mode key (TV, DVD, VCR, . [. . . ]