User manual THOMSON ROC5209

[. . . ] note 2: To control 2 devices of the same type and the same brand (2 Thomson VCRs , 2 Thomson satellite receivers , . ) ensure first that these two devices are not set to react to the same sub code, they will require one sub code for one and a different sub code for the other (i. Once you have checked this, successively program 2 separate mode keys using method D. Method A ­ Fast programming with 1-digit subcode Before you start programming, you must find the subcode of the set to be controlled. [. . . ] Depending on the format of the transmission codes of the original remote control, your ROC5209 remote control can memorise up to 150 keys. Global delete ­ Delete all the keys copied (this is recommended the first time you use this function) 1. The batteries in the 2 remote controls must be in good condition; change them if necessary. First copy 2 or 3 keys from the original remote control in order to check the compatibility of the codes of both remote controls. Then carry out a global delete of these keys before starting the full learning procedure. Lay out the original remote control and your ROC5209 end to end so as to align the LED diodes on the 2 remote controls. Where necessary adjust the height of both remote controls so that the LED diodes are properly aligned. Place the remote controls with the infrared diodes on a table so that they point each other at a distance between 15 and 50 mm. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Method C ­ Programming by means of code retrieval Should none of the codes work, you still have the possibility of retrieving the appropriate code without having to perform any input. Hold down the SETUP key until the red indicator lamp blinks and then remains lit. Press the key that corresponds to the type of equipment you want to control: TV: television set, DVD: DVD player, VCR: Video recorder, SAT/CABLE: satellite receiver, cable, DVBT, ADSL, AUDIO/AUX: audio equipment and any other appliance. Direct the remote control towards the set and try to switch it off by pressing the key G. If the set you want to control switches off, press OK to memorise the code. Should the set not switch off, press key G as many times as required (up to 200 times), until the set switches off. Between two key presses, leave enough time for the key corresponding to the red indicator lamp to light up again (about 1 second). Proceeding this way will enable you to see whether the set responds or not. Check of the programming: In principle, your set is ready for receiving the remote control commands. Check your remote control for proper functioning by performing the test described on page 2. Try out other remote control keys to find out the range of functions you can control. If you think that not all of the keys are active, repeat the procedure of this programming method to find out the code supporting a wider range of features. [. . . ] You simply press the Page key on the base and the remote sounds with a tone, making it easy to locate. Match the batteries to the + and ­ marks inside the battery case, then insert 2 AAA batteries. The batteries must be disposed of at a special collection point for used batteries Open the cover on the back of the remote control by pushing down on the tab and lifting the cover off. When exchanging the batteries, it may be necessary to reprogram the unit. [. . . ]