User manual THOMSON RR520U

[. . . ] CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THE EXCLAMATION POINT WITHIN THE TRIANGLE IS A WARNING SIGN ALERTING YOU OF I M P O R TA N T INSTRUCTIONS A C C O M PA N Y I N G T H E P R O D U C T. CAUTION · Do not use your set immediately after transport from a cold place to a warm place: there may be condensation problems. To prevent any accident due to this type of beam, the set should only be opened by properly-trained personnel. · Make sure that you keep your set away from water and high temperatures. [. . . ] When AC power is interrupted (disconnected) for a short period of time, both time and alarm settings will change (unless optional battery is installed). After AC power is restored (reconnected), the Digital Display will blink to indicate that power was interrupted and you should readjust the time and alarm settings. Remove battery compartment door (located on the bottom of the radio) by applying thumb pressure to area indicated on battery door and then lift the door out and off the cabinet. Insert battery in the compartment and replace the compartment door. EN AC Connections . . . . . . . . . . . . . 6 Care and Maintenance 13 NOTE: Alkaline (6LR61/NEDA 1604A) batteries are recommended. Carbon-zinc battery may be used but memory holding time will be substantially reduced. Memory holding time for a fresh alkaline battery is approximately 8 hours (if radio or alarm are not operated) which should take care of short, nuisance-type AC power failures. To preserve battery life, the unit should remain plugged into an AC outlet. Battery should be removed if the unit will be stored for more than one month. Leaky battery can badly damage the clock radio. 1 RR520U EN rev. 1 4-5 9/10/02, 6:00 PM THE DIGITAL CD CLOCK RADIO Have a Blast- Just Not in Your Eardrums!Make sure you turn down the volume on the unit before you put on headphones. Before display switches back to clock time, press TUNING/TIME DN or UP to set nap time. Nap time decrease or increase at 10 -minute intervals between 10 and 120 minutes. The display returns to the real 4 1 1&2 Press RADIO ON/BAND turn on the radio. Press again to 2 to select FM/MW. 3 5 4 Press TUNING/TIME DN or UP repeatedly to manually set to your desired station. The frequency will decrease or increase as you press the respective buttons. Alarm will sound once the timer reaches 0:00. 5 Press and hold NAP timer. until the NAP indicator disappears to cancel NAP · To improve reception, you may try and: 1. slide the FM RADIO switch on the back of the unit to mono MO for FM reception · To turn off the radio, press . TIP: To check the remain NAP timer, press NAP The display will show the NAP. After 3 seconds, the display will return to clock time. Automatic Station Search Press and hold either TUNING/TIME DN or UP for more than 1 second and release. Automatic station search starts and stops when channel is found. 8 9 RR520U EN rev. 1 12-13 9/10/02, 6:00 PM THE DIGITAL CD CLOCK RADIO Radio Frequency Memory 1 THE DIGITAL CD CLOCK RADIO Listening to compact disc 4 EN 1 Refer to "Listening to Radio" to tune to the station to be stored in memory. Preset station number will flash on the display and will be automatically assigned (the next available number). if you want to select Press OPEN 1 the door. to open 2 2 1 Insert a disc and press the door close. [. . . ] · Do not use record cleaning sprays or anti-static agents on discs. Also, never clean discs with benzene, thinner, or other volatile solvents which may cause damage to the disc surface. CD Lens Care When your CD lens gets dirty it can also cause the unit to output poor sound quality. To clean the lens you will need to purchase a CD lens cleaner which can maintain the output sound quality. For instructions on cleaning the CD lens, refer to the ones accompanying the lens care. Cleaning the Exterior Prior to cleaning the exterior, be sure to unplug the power cord from the AC power outlet. [. . . ]