User manual TRITON T40I

[. . . ] 1. 11 DO NOT use excessive force when making connections to the flexible hose or sprayhead, finger tightness is sufficient. 1. 12 All hose connections MUST be completed BEFORE making the electrical connections 2. 1 The installation must comply with BS 7671 `Requirements for electrical installations' (IEE wiring regulations) or any particular regulations as specified by the local Electrical Supply Company. (Safety) Regulations 1994', this appliance is intended to be permanently connected to the fixed wiring of the electrical mains system. 2. 4 Make sure all electrical connections are tight to prevent overheating. [. . . ] Note: The control knob is an integral part of the cover - DO NOT attempt to remove it. If top entry position is chosen, the cut-out in the backplate must be removed (fig. 7). Loosely connect the flexible hose supplied to the T40i inlet connection and the mixer valve outlet. Using the backplate as a template, hold it against the wall, making sure there is some slack in the hose and mark the position of the fixing holes (fig. 8). (The wallplugs provided are suitable for most brick walls ­ use an appropriate masonry drill, but if the wall is plasterboard or a soft building block, you must use special wallplugs and an suitable drill bit). Screw the top fixing screw into position leaving the base of the screw head protruding 6mm out from the wall. Hook the backplate over the top screw and fit the bottom fixing screw into position. The bottom fixing hole is elongated to allow for out of square adjustment. 8 6 T40i HOSE CONNECTIONS Fitting to: Bath tap/mixer valve (fig. 2) Mixer valve (fig. 3) Push on with blender valve (fig. 4) Remove the existing sprayhead flexible hose from bath tap/mixer valve/blender mixer arrangement. Screw one end of the flexible hose supplied, to the T40i inlet connection using one of the sealing washers to seal the joint. Screw the other end of the flexible hose to the mixer outlet using the washer provided to seal the joint. Screw the sprayhead flexible hose to the outlet of the T40i pump using the washer provided to seal the joint. Hold the end of the hose to waste and turn the water on to flush the system and to check for leaks. Leave running to waste until a smooth (even if poor) flow of water is obtained. Turn off the water. Fig. 9 Existing hose Hose supplied Fitting to: Push-on type connection (fig. 5) and (fig. 9) Unscrew the sprayhead from the existing hose then connect the hose to the T40i inlet. Note: This is only possible if the hose terminates with a ½" BSP connection. Connect the hose supplied to the T40i outlet using the washer provided to seal the joint. Hold the end of the hose to waste and turn the water on to flush the system and to check for leaks. Turn the water on again and leave running to waste until a smooth (even if poor) flow of water is obtained. Turn off the water. 7 T40i Fig. 10 ELECTRICAL CONNECTIONS L Terminal block N E WARNING!Note: A double pole linked switch with a minimum contact gap of 3mm in both poles must be fitted in the circuit. The supply cable must conform to relevant tables in current IEE regulations. [. . . ] This guarantee applies only to products installed within the United Kingdom and does not apply to products used commercially. What is not covered: 1 Breakdown due to: a) use other than domestic use by you or your resident family; b) wilful act or neglect; c) any malfunction resulting from the incorrect use or quality of electricity, gas or water or incorrect setting of controls; d) faulty installation. 4 Compensation for loss of use of the product or consequential loss of any kind. 6 The cost of repair or replacement of pressure relief devices, sprayheads, hoses, riser rails and/or wall brackets, isolating switches, electrical cable, fuses and/or circuit breakers or any other accessories installed at the same time. [. . . ]