User manual UNI-T DT 830

[. . . ] · The indicator hand will move to the city code that is currently selected as the Home City. · The bottom dial hand also will indicate the current 30 DST on/off setting at this time. Press D to move the indicator hand clockwise, until it points at the city code you want to select as your Home City. Bottom dial hand · For full information on city codes, see the "City Code Indicator hand Table". [. . . ] Pressing C will cause the watch to beep twice. 3 30 0 Month Day 12. After all of the settings are the way you want and the day display is no longer changing, press A. This will cause the bottom dial hand to start moving again and the other hands to start moving from their current positions. · You can press A at any time during the above procedure to return to regular timekeeping. · The watch's built-in full automatic calendar makes allowances for different month lengths and leap years. Once you set the date, there should be no reason to change it except after you have the watch's battery replaced. Stopwatch Indicator hand Stopwatch hours (24-hour format) 30 Stopwatch minutes Stopwatch 1/20 seconds The stopwatch lets you measure elapsed time. · When you enter the Stopwatch Mode, the bottom dial hand moves to 12 o'clock and the right dial hands move to 12 o'clock. · You can start elapsed time measurement with the stopwatch while the watch is in the Stopwatch Mode or the Timekeeping Mode. · The display range of the stopwatch is 23 hours, 59 minutes, 59. 95 seconds. · The stopwatch continues to run, restarting from zero after it reaches its limit, until you stop it. · You can switch to another mode from the Stopwatch Mode only while the stopwatch is stopped and reset. To start an elapsed time operation while in the Stopwatch Mode 1. At the same time, the right dial hands will move to the current time in that city. · If the current time shown for a city is wrong, check your Home City settings and make the necessary changes. · All of the operations in this section are performed in the World Time Mode. To adjust the home positions 1. In the Timekeeping Mode, as you hold down A, hold Indicator hand down C for about three seconds until the watch beeps. · This indicates that the watch is in the home position adjustment mode. · If the bottom dial hand moves to 12 o'clock, it is in the correct home position. If it doesn't, use D to move the bottom dial hand to 12 o'clock. 30 · The indicator hand is also in the proper home position if it moves to 12 o'clock. If it doesn't, press B to move it to 12 o'clock. Bottom dial hand Correct bottom dial hand and indicator hand home positions To view the time in another city In the World Time Mode, use D to move the indicator hand clockwise to the city code of the city you want to select as the World Time City. · The right dial hands will move to indicate the current time in the selected city code. · For full information on city codes, see the "City Code Table". [. . . ] · The day is in the correct home position if it shows "1". If it doesn't, use D (+) and B (­) to change the day to "1". To return to regular timekeeping, press A. Swapping your Home City and World Time City You can use the procedure below to swap your Home City and World Time City. This changes your Home City to your World Time City, and your World Time City to your Home City. [. . . ]