User manual VISONIC DUO AM K9 85

[. . . ] Do not install the unit directly above cooking appliances, directly above a sink, or adjacent to extractor fans. When the alarm sounds, immediately find out the cause and remedy it or evacuate the building · Ventilate the area by opening doors and windows · Immediately extinguish any flames or pilot lights · Do not operate any electrical devices · determine the source of the gas. Seek a qualified technician or call your local gas company Compatibility: Compatible with all PowerMax alarm system family (PowerMax / PowerMax+ / PowerMax Pro / PowerMaxComplete), MCR-304 receiver, MCR-308 receiver or any other PowerCode alarm system. Important: The detector will not operate without 220V power connection. [. . . ] Important: The detector will not operate without 220V power connection. In the event of a power failure or where the detector is not connected to a power source, an AC failure message is sent to the control panel (will be received by PowerMax+ version 3. Therefore, when installing the DUO AM K9 85, to work with PowerMax or PowerMax+ revision 2. 9 and down, it is highly recommended not to disable the PowerMax/PowerMax+ "supervision" function (See "Define Control Panel Parameters" in the PowerMax Programming Guide or PowerMax+/PowerMax Pro/PowerMaxComplete Installer Guide). Refer to the target receiver's installation instructions and follow the procedure given there for "teaching" IDs. When you are instructed to initiate a transmission from the DUO AM K9 85, press the Test / Silent button (see Figure 1). 9 and down, you have to cause the detector not to send AC failure messages, as follows: Continuously press the Test/Silent button for 10 seconds approximately, until a long beep (2 seconds) is heard. This beep indicates that the detector will not to send AC failure messages. To return to AC failure reporting capability, repeat the above action. Note: In the event of a gas leakage, the smell of the gas may be in the air before the detector activates the alarm. To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. All products, accessories or attachments of others used in conjunction with the Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. This Warranty is exclusive to the original Purchaser and is not assignable. This Warranty is in addition to and does not affect your legal rights. Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. Warning: The user must follow the Manufacturer's installation and operational instructions including testing the Product and its whole system at least once a week and to take all necessary precautions for his/her safety and the protection of his/her property. Use the Test / Silent button (see Figure 2) to switch off the acoustic alarm tone in the event of an alarm. [. . . ] Any provision in this warranty which is contrary to the Law in the state or country were the Product is supplied shall not apply. Warning: The user must follow the Manufacturer's installation and operational instructions including testing the Product and its whole system at least once a week and to take all necessary precautions for his/her safety and the protection of his/her property. Use the Test / Silent button (see Figure 2) to switch off the acoustic alarm tone in the event of an alarm. The red LED will continue to flash and a short signal tone will sound approximately every 45 seconds. [. . . ]