User manual VISONIC K9 85

[. . . ] Dispose of used battery according to the manufacturer's instructions. Nominal Battery Capacity: 6V 1450 mA/h (2xCR123A), 2200 mA/h (2xCR17450) Battery Life (for typical use): 4 to 5 years (CR123A) / 8 years (CR17450). Power Supply: Type C FUNCTIONAL True Motion Event Verification: 2 remote selections - 1 (OFF) or 2 (ON) motion events IR Illumination: 10 m (33 ft) Picture Resolution: 320x240 pixels QVGA Frame Rate: up to 2 fps (for user) Alarm Period: 2 seconds A. Next CAM PG2: 0. 54m, Next CAM-K9 PG2: 2-4m 9 (30ft) 6 (20ft) 3 (10ft) 0 3 (10ft) 6 (20ft) 9 (30ft) 90° A 0 3 10 6 20 9 30 12 m 40 ft B 2. 4 m (8 ft) C 0 3 10 6 20 9 30 12 m 40 ft Fig. [. . . ] For 30 days per year relative humidity may vary between 85 % and 95 % non-condensing. Compliance with Standards: USA: Designed to meet FCC Part 15 Europe: Directive 1999/5/EC of the European Parliament. EN 50131-2-2, EN 50131-6 PHYSICAL Size (H x W x D): 125 x 63 x 60 mm (4-15/16 x 2-1/2 x 2-3/8"). ENROLLMENT Refer to the control panel Installer Guide for the device enrollment procedure. 4. Next CAM PG2 / Next CAM-K9 PG2 DEVICE SETTINGS This section describes how to configure the parameters of the PIR detector from the control panel. To Modify the PIR Detector Device Settings Refer to the control panel Installer Guide and perform the procedure for Adding A Wireless Device (section 4. 5. 2), or, Modifying a Device (section 4. 5. 5). or Select between "NOT Active", "YES ­ no delay", "YES + 5s delay", "YES + 15s delay", "YES + 30s delay", "YES + 1m delay", "YES + 2m delay", "YES + 5m delay", "YES + 10m delay", "YES + 20m delay" and "YES + 60m delay". or Select between "LOW sensitive" and "HIGH sensitive". Here you determine whether an alarm will be activated upon continued motion (low sensitivity) or upon a single alarm event (high sensitivity). Here you determine whether or not the alarm LED indication will be activated. 12. Settings When exiting "INSTALLLER MODE" menu, the alarm system displays the number of devices that need to be updated, as follows: "DEV UPDATING NNN". SPECIAL COMMENTS Even the most sophisticated detectors can sometimes be defeated or may fail to warn due to: DC power failure / improper connection, malicious masking of the lens, tampering with the optical system, decreased sensitivity in ambient temperatures close to that of the human body and unexpected failure of a component part. The above list includes the most common reasons for failure to detect intrusion, but is by no means comprehensive. It is therefore recommended that the detector and the entire alarm system be checked weekly, to ensure proper performance. Home and property owners or renters should be prudent enough to continue insuring their lives and property, even though they are protected by an alarm system. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception. WARRANTY Visonic Limited (the "Manufacturer") warrants this product only (the "Product") to the original purchaser only (the "Purchaser") against defective workmanship and materials under normal use of the Product for a period of twelve (12) months from the date of shipment by the Manufacturer. This Warranty is absolutely conditional upon the Product having been properly installed, maintained and operated under conditions of normal use in accordance with the Manufacturers recommended installation and operation instructions. Products which have become defective for any other reason, according to the Manufacturers discretion, such as improper installation, failure to follow recommended installation and operational instructions, neglect, willful damage, misuse or vandalism, accidental damage, alteration or tampering, or repair by anyone other than the manufacturer, are not covered by this Warranty. The Manufacturer does not represent that this Product may not be compromised and/or circumvented or that the Product will prevent any death and/or personal injury and/or damage to property resulting from burglary, robbery, fire or otherwise, or that the Product will in all cases provide adequate warning or protection. [. . . ] THE MANUFACTURER SHALL HAVE NO LIABILITY FOR ANY DEATH, PERSONAL AND/OR BODILY INJURY AND/OR DAMAGE TO PROPERTY OR OTHER LOSS WHETHER DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL OR OTHERWISE, BASED ON A CLAIM THAT THE PRODUCT FAILED TO FUNCTION. However, if the Manufacturer is held liable, whether directly or indirectly, for any loss or damage arising under this limited warranty, THE MANUFACTURER'S MAXIMUM LIABILITY (IF ANY) SHALL NOT IN ANY CASE EXCEED THE PURCHASE PRICE OF THE PRODUCT, which shall be fixed as liquidated damages and not as a penalty, and shall be the complete and exclusive remedy against the Manufacturer. 1/08 However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures: ­ Re-orient or re-locate the receiving antenna. [. . . ]