User manual VISONIC MCT 320

[. . . ] This neck cord must never be replaced with a cord that does not include a safety release. Figure 3 - Clip Attachment 2. SPECIFICATIONS Frequency (MHz): 315, 433. . 92, 868. 95, 869. 2125, 869. 2625 or other frequency according to the requirement in the country of use. Frequency Tolerance: ± 120 kHz Channel Bandwidth: 500 kHz Transmitter Output Power: <10 dBm Modulation: A. S. K (on-off keying) Encoding: Factory programmed, 24-bit digital word Transmission Duration: 3 seconds (even if the user keeps the transmission button depressed shorter or longer than that) Power Supply: 3 V CR-2 type Lithium battery Battery Life Expectancy: Up to 7 years, based on one transmission per day Caution! [. . . ] Operating Temperature: 0°¡ to 50°C (32°F to 122°¡F) Dimensions (H x W x D): With Clip: 73 x 41 x 30 mm (2-7/8 x 1-5/8 x 1-3/16 in. ) Without Clip: 67 x 41 x 21 mm (2-5/8 x 1-5/8 x 13/16 in. ) Weight: 35 g (with clip), 30 g (without clip) Color: Gray Compliance with Standards: ETS 300 683, EN300220, EN 50131-1 Grade 2 Class II. This device complies with the essential requirements and provisions of Directive 1999/5/EC of the European Parliament and of the Council of 9 March 1999 on radio and telecommunications terminal equipment. The technical documentation as required by the European Conformity Assessment procedure is kept at: UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. Telephone number: 0870 7300800, Fax number: 0870 7300801 C. Battery Condition Indication and Reporting: A. Low battery - when transmission button is pressed, "low battery" alarm code is transmitted and the LED flashes. DE2276U 1 3. MISCELLANEOUS COMMENTS 3. 1 Product Limitations Our wireless systems are very reliable and are tested to high standards. However, due to their low transmitting power (required by FCC, DTI and other regulating authorities) there are some limitations to be considered: A. Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the code selected. Wireless equipment should be tested regularly (at least once a week) to determine if there are sources of interference and to protect against faults. The Manufacturer shall be under no liability whatsoever arising out of the corruption and/or malfunctioning of any telecommunication or electronic equipment or any programs. The Manufacturers obligations under this Warranty are limited solely to repair and/or replace at the Manufacturer's discretion any Product or part thereof that may prove defective. Any repair and/or replacement shall not extend the original Warranty period. The Manufacturer shall not be responsible for dismantling and/or reinstallation costs. To exercise this Warranty the Product must be returned to the Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. All products, accessories or attachments of others used in conjunction with the Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. [. . . ] The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. This Warranty is exclusive to the original Purchaser and is not assignable. This Warranty is in addition to and does not affect your legal rights. [. . . ]