User manual VISONIC MKP 151

[. . . ] INTRODUCTION NOTE: RELEVANT TO POWERMAX+ VERSION B AND ABOVE The MKP-150 / MKP-151 (different color) operates using two-way encrypted coded transmission and provides aural and visual indications. For each PowerMax+, PowerMax Pro, PowerMaxComplete, PowermaxExpress control panel, a maximum of two MKP-150/MKP-151 keypad devices may be enrolled. Partitioning allows you to have up to three independently controllable areas with different user codes assigned to each partition or one user code assigned to up to three partitions. A partition can be armed or disarmed regardless of the status of the other partitions within the system. [. . . ] RECORD SPEECH This mode allows you to record up to 5 custom zone names. SERIAL NUMBER Enables reading the system serial number for support purposes only. The installer's menu is accessible only to those who know the installer's code, which is 9 9 9 9 by factory default. Press the next button () repeatedly until the display reads: INSTALLER MODE B. The display should read: ENTER CODE: ___ Note: For control panels with two installer codes, the default INSTALLER code is 8888 and the default MASTER INSTALLER code is 9999. Press <> to set the selected option. 5. 1. 2 To Activate the Recording Mode A. Upon gaining access to the installer menu (see section 5. 1. 1 A to C), the display will read "SUPERVISION". The display will change to: USER TERM #1 Note: User Term refers to the name assigned to the recorded zone. Note: It is recommended to assign custom names that are identical to the custom names defined in the control panel. Press the key until this is displayed briefly: RECORD A MESSAGE Immediately thereafter, the display will change to: 5. 1. 1 To Set Supervision Time Make sure the system is not in Arm mode. TALK NOW 3 DE2462U E. Do not release the key and start talking immediately (for example, living room or library), while facing the front panel. The dark square boxes will slowly disappear one by one, from right to left. When the last one disappears (5 seconds later) the following message will be displayed: 5. 1. 4 Keypad Back Light RECORDING ENDED F. Upon gaining access to the installer menu (see section 5. 1. 1 points A to C) the display will read "SUPERVISION". Press <> to set the selected option. 5. 1. 5 Jam Detection A. Upon gaining access to the installer menu (see section 5. 1. 1 points A to C) the display will read "SUPERVISION". Press <> to select between UL 20/20, EN 30/60, class 6 (30/60), disable and other. Repeat the procedure for User Terms #2 - #5 to record the names of zones 2 - 5. 5. 1. 3 To Enable/Disable Piezo Beeps A. Upon gaining access to the installer menu (see section 5. 1. 1 points A to C) the display will read "SUPERVISION". Press <> to select between enable beeps, off when home and disable beeps. Light by Sensor (for further details, refer to the control panel User's Guide). USER SETTING B. The display will change to: Note: If the bypass function is disabled, the display will change to: SET PHONE NUMBER D. [. . . ] All freight and insurance costs are the responsibility of the Purchaser and are not included in this Warranty. This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any person to act on its behalf in the modification, variation or extension of this warranty. All products, accessories or attachments of others used in conjunction with the Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of others, including batteries, used in conjunction with the Products. [. . . ]