User manual WACOM PENPARTNER

[. . . ] Getting Started with PenPartner the WACOM Tablet Driver CD contains the installation software and the Readme file. Some configurations may also contain some additional application software. Click on the "Install Tablet" button and follow the prompts to connect your tablet hardware and install the driver software. If this happens, click on OK and enter the path for theWindows CAB files (for example d:Â¥win98). [. . . ] Make sure your computer is turned on, the operating system has finished loading, and the tablet is properly connected to an active USB port. The tablets orange status LED will light whenever the tablet is properly connected and your computer has registered it as a USB device. If you are connecting the tablet to a USB hub (or hub device such as a keyboard with USB ports), be sure the USB hub is properly connected to your computer and is active. â· Connect the tablet into a different USB port or try connecting to the USB port on another computer. â· If the tablets status LED does not illuminate after your computer is on and has finished booting up, your USB port may be disabled. Move your pen across the active area of the tablet; the screen cursor should move in the corresponding direction on your monitor. Now, without applying pressure to the pen tip, hold the pen tip within 5 mm (0. If you encounter problems with your tool(s) or tablet, refer to the following tables. Your problem may be described here, and you can try the solution offered. The computer does not Check if there is an available USB port on a USB have an available USB port. If you are connecting to a USB hub device, make sure the hub is connected to an active USB port and that the hub is active. The tablet driver software was not installed or did The pen works only in not load properly. Mouse mode, and does Make sure the tablet driver software is installed not draw with pressureand functioning. Select the CLICK SOUND option (the check box should be checked) so that you can hear when the pen registers a mouse click. Note that your computer speakers must be turned on and the volume audible before you can hear CLICK SOUND. Be sure you are quickly tapping the tablet twice in the same place on the tablets active area. You notice a screen delay In the Tablet control panel, try decreasing the DOUBLE-CLICK DISTANCE. Make sure the status LED changes from orange to green when the tip is pressed. Be sure you press the side switch when the pen tip The side switch does not is in proximity--do this without pressing down work. Make sure the tablet status LED changes from orange to green when you press the side switch. Do not place the pen on the tablet when using The screen cursor jumps another pointing device. Leaving your tool on the back when using your regular mouse or trackball. [. . . ] on a multiple monitor system , the tablet is mapped to the virtual desktop (a rectangular area covering all monitors). If your video display areas do not form a rectangle because they are different sizes or they are not evenly aligned, the screen cursor positioning will be incorrect after moving into the unmapped area of the virtual desktop. To reestablish the correct screen cursor position, lift your tool out of tablet proximity and bring it back into proximity over an area of the tablet that is mapped to a display area. Reboot the system after installing the tablet on a system with multiple users. [. . . ]