User manual WAGNER PAINTMATE PLUS

[. . . ] Using a cleaning solution stronger than mineral spirits may cause damage to the PaintMate® Plus. Check with your paint supplier to be sure the oil-based paint you have can be cleaned with mineral spirits. [. . . ] NOTE: These steps should be followed for cleanup of latex paints ONLY. Submerge the fill tube into warm, soapy water and pull the plunger in and out a minimum of 5 times. Submerge the connecting area and valve housing under the solvent and pull the plunger in and out five a minimum of 5 times. NOTE: When storing your PaintMate® Plus, make sure the fill valve is pointing downward, and never store your unit with the fill tube inserted into the fill valve. Turn the locking collar next to the trigger counterclockwise until the main tube easily slides off the plunger. Remove the fill tube, then submerge the fill valve and the roller arm and pull the plunger in and out a minimum of 5 times. Submerge the connecting area and the fill valve under warm, soapy water and pull the plunger in and out a minimum of 5 times. Thoroughly pack a generous amount of petroleum jelly around and in between the O-rings on the plunger. NOTE: These steps should be followed for cleanup of oil-based paints ONLY. Submerge fill tube into a gallon can of mineral spirits and pull plunger in and out a minimum of 5 times. Remove fill tube, then submerge roller arm into the same one gallon bucket of mineral spirits, making sure that ALL of the holes in the roller arm are submerged. NOTE: When putting the plunger back into the main tube, make sure the O-rings do not twist or cut. [. . . ] This warranty does not cover damage resulting from improper use, accidents, user's negligence or normal wear. This warranty does not cover any defects or damages caused by service or repair performed by anyone other than a Wagner Authorized Service Center. [. . . ]