User manual WESTINGHOUSE PHN668U

[. . . ] · Children should be supervised to ensure that they do not play with the appliance. To avoid burns young children should be kept away General Safety · The appliance may only be installed and connected by trained, registered service engineers. · Built-in appliances may only be used after they have been built into suitable built-in units and work surfaces that meet standards. · In the event of faults with the appliance or damage to the glass ceramic (cracks, scratches or splits), the appliance must be switched off and disconnected from the electrical supply, to prevent the possibility of an electric shock. [. . . ] Energy saving Always place cookware on the cooking zone before it is switched on. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. If possible, always place lids on the pans. westinghouse 7 Bottom of pans and cooking zones should be the same size. Cleaning and Care Warning!Sharp objects and abrasive cleaning materials will damage the appliance. Removing deposits Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discoloration at once yes yes ------when the appliance has cooled down ----yes yes yes using a scraper1) a scraper1) cleaner for glass ceramic or stainless steel 1) cleaner for glass ceramic or stainless steel1) cleaner for glass ceramic or stainless steel1) 1) *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialized shops Removing deposits 1. Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. Remove residues with water and washing up liquid. 8 westinghouse What to do if . . . Problem The cooking zones will not switch on or are not functioning. Possible cause More than 10 seconds have passed since the appliance was switched on The child safety device is switched on Several sensor fields were touched at the same time Automatic switch off has been triggered Remedy Switch the appliance on again. Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove any objects (pan, cloths, etc. ) that are lying on the control panel. Switch the appliance on again Switch off the lock (See the section "Locking/unlocking the control panel") Remove objects. The lock is switched on Acoustic signal sounds when appliance is switched off The control panel is wholly or partly covered by objects. The residual heat indicator The cooking zone was only on for a is not displaying anything short time and is therefore not hot The automatic warm up There is still residual heat on the function is not switching it- cooking zone self on The highest heat setting is set If the cooking zone is supposed to be hot, call the Customer Service Department. Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field Do not place any objects on the control panel The heat setting was set using the sensor field Acoustic signal sounds and appliance switches itself on and then off again; after 5 seconds another acoustic signal sounds is lit The On/Off sensor field has been covered up, e. g. by a cloth Overheating protection for the cooking zone has been triggered Automatic switch off has been triggered Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, is displayed again, call the customer service department and number are displayed Electronics fault If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. Do not use silicon 10 westinghouse sealant between the appliance and the work top. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. · The appliance must be connected to the electrical supply by a qualified electrician. · Loose and inappropriate plug and socket connections can make the terminal overheat. · Have the clamping connections correctly installed by a qualified electrician. To avoid a hazard, underbench access must be restricted Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. Also check the power rating of the appliance and ensure that the wire is suitably sized in accordance with local wiring rules to suit the appliance power rating. [. . . ] Limitation of Liability To the extent permitted by law: ­ Electrolux excludes all warranties other than as contained in this document; ­ Electrolux shall not be liable for any loss or damage whether direct or in- direct or consequential arising from your purchase, use or non-use of the Appliance. Provisions of the Trade Practices Act and State consumer legislation in Australia, and the Consumer Guarantees Act, the Sale of Goods Act and the Fair Trading Act in New Zealand, imply warranties or conditions, or impose obligations, upon Electrolux which cannot be excluded, restricted or modified. To the extent permitted by law, the liability of Electrolux (if any) arising out of or in relation to the Appliance or any services supplied by Electrolux shall be limited (where it is fair and reasonable to do so), : ­ in the case of Appliances, at its option, to the replacement or repair of the Appliances or the supply of equivalent products or the payment of the cost of replacing the Appliances or having the Appliances repaired or of acquiring equivalent Appliances. Upon being replaced, parts and Appliances become the property of Electrolux; or ­ in the case of services, at its option, to the supply of the services again or the payment of the cost of having the services re-supplied; and in the case of Appliances or services supplied in New Zealand, loss or damage whether direct or indirect or consequential that is reasonably foreseeable. [. . . ]