User manual WHIRLPOOL DW681ES FP WH AA INSTRUCTION FOR USE

[. . . ] • Make sure the inlet and drain hoses are kink-free and are not crushed. • If the hose length is not sufficient, please contact your local dealer or our Authorised Service Center. • The inlet hose must be securely clamped to the water tap to prevent leaks. • When installing the appliance, make sure the drain water discharges correctly (if necessary, remove the wire gauze from the sink siphon). [. . . ] Safety warnings: • The open dishwasher door can only support the weight of the loaded rack when pulled out. Do not rest objects on the open door or sit or stand on it: the appliance may topple over!• Sharp knives and forks that might cause injury must be placed in the cutlery basket with the sharp end facing downwards. Long-handled utensils must be arranged horizontally in the upper rack, with the sharp end facing away from the front of the appliance. Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. If a fault occurs, switch off the appliance and turn off the water tap. On completion of the programme switch off the dishwasher and turn off the water tap. Repairs and technical modifications must be carried out exclusively by a qualified technician. Resistance to frost If the appliance is placed in surroundings exposed to the risk of frost, it must be drained completely. Turn off the water tap, remove the flexible inlet and outlet hoses, and let all the water run out. For appliances with water stop system: The water inlet hose and plastic casing contain electrical components. The appliance must be used at temperatures between 5°C and 45°C. 7. 8. 5 HOW TO FILL THE RINSE AID DISPENSER The rinse aid facilitates drying and prevents the formation of unsightly spots and streaks on crockery. Before using the dishwasher for the first time, fill the rinse aid dispenser. Fill the dispenser with rinse aid up to the dotted line (about 100 ml maximum). This prevents the formation of excess suds which may spoil washing results. Thereafter, regularly check the rinse aid level. A How to adjust the rinse aid dosage regulator Factory setting: Position 4. If you are not satisfied with washing or drying results, change the rinse aid dosage setting. If crockery is prone to whitish streaks: reduce the dosage by turning the dial to a lower setting (1-3) using a coin or the like. If crockery is not perfectly dry: increase the dosage by turning the dial to a higher setting (5-6). Rinse aid level indicator: Visual indicator: add rinse aid light sufficient rinse aid. dark Electric indicator (if provided): The indicator lamp on the control panel lights up when more rinse aid needs to be added. At the end of the wash programme, the amount of rinse aid on dishware is minimal and not harmful in this quantity. [. . . ] To reassemble: insert the wide-mesh filter into the microfilter so it clicks into place. Insert the wide-mesh filter / microfilter unit and turn clockwise (in the direction of the arrow “1”), until the dashed lines on the microfilter and fine-mesh filter are aligned. Email: customer. care@fp. co. nz Postal address: P. O. Box 58732, Greenmount, Auckland If you need service. . . * Fisher & Paykel has a network of independent Fisher & Paykel Authorised Customer Service Centres whose fully trained technicians can carry out any service necessary on your appliance. Your dealer or our Customer Care Centre can recommend an Authorised Service Centre in your area. In Australia if you need assistance. . . * Call the Fisher & Paykel Customer Care Centre and talk to one of our Customer Care Consultants. [. . . ]