User manual WHIRLPOOL LAB0050PQ PEDESTRAL INSTALLATION

[. . . ] We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. [. . . ] Pull the washer away from the wall so the pedestal can be placed in its final location. Excessive Weight Hazard Use two or more people to move and uninstall dryer. Loosen the clamp and slowly remove the exhaust vent from the dryer exhaust outlet. Pull the dryer away from the wall so the pedestal can be placed in its final location. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. 2 cm) must be added under pedestal so that the dryer is 18" (46 cm) above garage floor. Use one bracket on each of the four feet to properly secure the washer/dryer to the pedestal. Excessive Weight Hazard Use two or more people to move and install pedestal. To install a washer/dryer to the pedestal, first thread a locknut onto each foot. When all 4 locknuts are in place on the feet, screw a foot into each corner brace of the pedestal. Adjust the feet so that the rubber pads extend just below the bottom of the pedestal and keep the pedestal at least ¹/" (3. NOTE: For more stability, do not raise the bottom of the pedestal any higher than necessary to clear the floor on all four sides. [. . . ] Be sure to completely tighten the brackets and locknuts again after the washer/dryer is level. Follow the Installation Instructions that came with your model to finish installing or reinstalling your washer or dryer (installing or reinstalling hoses, vents, etc. [. . . ]