User manual WHIRLPOOL RMX305

[. . . ] · This oven is designed solely for use as a home appliance for cooking food. The manufacturer assumes no responsibility for damage caused by improper or incorrect use. · Any repairs or servicing must be carried out exclusively by a qualified technician. · Do not put heavy objects on the door because they could damage the oven cavity and hinges. [. . . ] · This appliance is not intended for us by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. · Keep children away from the following elements as they are sources of danger: - the oven and its controls, especially when in operation and immediately afterwards to avoid injury. - packaging (bags, polystyrene, metal parts, etc. ) - an oven to be scrapped. · Make sure that the electrical cables of other appliances used near the oven do not touch hot parts and are not trapped in the oven door. · Some oven models are equipped with an air cooling system to prevent the front of the oven and cabinet cavity from reaching excessively high temperatures. Attention: Steam and smoke are vented through an opening located between the control panel and the oven door. · Do not place inflammable material in the oven or nearby: a fire may break out if the oven is inadvertently switched on. · Use oven gloves to remove pans and accessories, when the oven is hot. · If alcoholic beverages are added when roasting or cooking cakes and sweets (for example, rum, cognac, wine, etc. ) remember that alcohol evaporates at high temperatures. It may happen that vapours released by the alcohol can catch fire when they are in contact with the electric heating element. · Do not heat sealed containers in the oven (except for packages specifically designed for this purpose; see the manufacturer's instructions). The pressure that develops inside the packaging might cause it to explode, damaging the oven. · At the end of the cycle and when the oven has cooled, use a damp sponge to remove any food residues. · Never clean the self-cleaning catalytic panels and rear cavity with abrasive products, rough brushes, pan scourers, or oven cleaner sprays, as they will lose their automatic cleaning properties. Accessories · Soak the accessories in water with washing up detergent immediately after use. Food residues can be easily removed using a brush or sponge. 72 Attention: When carrying out the following operations it is advisable to wear protective gloves. These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. Lift the two catches and push them forwards as far as they go (see fig. Remove the door by closing it partially and pulling it upwards (see fig. Attention: These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges. 1 2 3 To lower the grill heating element (certain models only) Do not attempt to clean the oven until it is cool. · Pull (4) the grill heating element slightly forward and lower it (5). 4 5 73 Changing the rear oven lamp bulb (if provided): 1. Let the oven cool before turning the lamp cover left to unscrew it (see fig. Note: use only 25 W/230 V, E-14 type, T300°C bulbs available from After Sales Service. Important: Do not use the oven until the lamp cover has been repositioned. 1 Changing the side wall lamp (if provided - depends on model): 1. [. . . ] Important: Do not use the oven until the lamp cover has been repositioned. 3 4 74 TROUBLESHOOTING GUIDE Oven not working: · Check for the presence of mains electrical power and if the oven is connected to the electrical supply. · Turn off the oven and restart it to see if the fault persists. IMPORTANT: · Check that the oven control knob is not turned to "0" or to the "lamp" symbol . - If the electronic programmer (depending on model) display presents the message " ", consult the product description sheet provided separately and/or the electronic programmer description. [. . . ]