User manual WHIRLPOOL UKF8001AXX

[. . . ] 6 cm) maximum below the support surface when the oven is installed in a wall cabinet. 5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box. NOTE: For undercounter installation, it is recommended that the junction box be located in the adjacent right or left cabinet. If you are installing the junction box on rear wall behind oven, the junction box must be recessed and located in the upper or lower right or left corner of the cabinet; otherwise, the oven will not fit into the cabinet opening. [. . . ] # 8­14 x 1" screws - single oven (2), double oven (4) Bottom vent (supplied on some models) Two # 8­18 x ³/" screws - bottom vent Side trim Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a single oven weight of 154 lbs (70 kg) or a double oven weight of 287 lbs (130 kg). IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet temperatures of 194° (90°C) 3 cm) bottom of cutout to floor D. If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path and the wire gauge are in accordance with local codes. Check with a qualified electrical installer if you are not sure the oven is properly grounded. This oven must be connected to a grounded metal, permanent wiring system. Be sure that the electrical connection and wire size are adequate and in conformance with the National Electrical Code, ANSI/NFPA 70-latest edition or CSA Standards C22. A copy of the above code standards can be obtained from: National Fire Protection Association One Batterymarch Park Quincy, MA 02269 CSA International 8501 East Pleasant Valley Road Cleveland, OH 44131-5575 To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection. If your home has: 4-wire Go to section: 4-wire Cable from Home Power Supply IMPORTANT: Use the 4-wire cable from home power supply in the U. Where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and recreational vehicles, new construction and in Canada. Green (or bare) ground wire (from oven) Connect the 2 white wires (D) and the green (or bare) ground wire (of the oven cable) using a UL listed wire connector. Excessive Weight Hazard Use two or more people to move and install oven. NOTE: Push against seal area of oven front frame when pushing oven into cabinet. With one # 8­18 x ³/" screw (C) for each side of the vent, fasten vent securely to the oven. Push against seal area of front frame to push oven into cabinet until shipping feet almost contact cabinet. On models with shipping feet, use a Phillips screwdriver to remove screws attaching the shipping feet. Push oven completely into cabinet and center oven into cabinet cutout. [. . . ] Push oven completely into cabinet and center oven into cabinet cutout. Securely fasten oven to cabinet using the # 8­14 x 1" screws (2 for single oven, 4 for double oven) provided. If there is an extra part, go back through the steps to see which step was skipped. Make sure the oven door is closed and the "ON" light is shown in the display. [. . . ]