User manual WHIRLPOOL WGT3300SQ

[. . . ] If you need assistance or service, first see the "Troubleshooting" section. Additional help is available by calling our Customer eXperience Center at 1-800-253-1301 from anywhere in the U. , or write: Whirlpool Corporation Customer eXperience Center 553 Benson Road Benton Harbor, MI 49022-2692 Information may also be obtained by visiting our website at www. In Canada, for assistance, installation or service, call us at 1-800-807-6777, or write: Whirlpool Canada LP Customer Interaction Centre 1901 Minnesota Court Mississauga, Ontario L5N 3A7 In Canada, visit www. [. . . ] Use a soft, damp cloth or sponge to wipe up any spills such as detergent or bleach. Clean your washer interior by mixing 1 cup (250 mL) of chlorine bleach and enough detergent to equal twice the manufacturer's recommended amount for a normal wash load. Pour this mixture into your washer and run it through a complete cycle using hot water. NOTE: Remove any hard water deposits using only cleaners labeled as washer safe. Remove dispenser by grasping top with both hands and squeezing, while pushing upward with thumbs. NOTE: If your model has a liquid fabric softener dispenser, do not wash clothes with this dispenser removed. Do not add detergent or bleach to this dispenser; it is for liquid fabric softener only. Separate the cover and the screen by squeezing the screen and pulling on the cover at the same time. Put the lint screen and cover back together and push firmly back into place. as Needed Cleaning Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. Clean the lint screen (as outlined following) every 6 months, or more frequently if it becomes clogged due to a residue buildup. A list of factory specified hoses available for separate purchase are listed on the first page of this user instructions. These hoses are manufactured and tested to meet Whirlpool Corporation's specifications. Replace water inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace water inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your water inlet hoses, mark the date of replacement on the label with a permanent marker. First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. Washer won't run, fill, rinse, or agitate; washer stops Is the floor flexing, sagging, or not level?Flooring that flexes or is uneven can contribute to noise and vibration of the washer. Evenly distribute the load in the washer basket and make sure the height of the load does not exceed the top row of basket holes. Are the gears engaging after the drain and before spin, or is the upper part of agitator clicking during wash? [. . . ] This limited warranty is valid only in the United States or Canada and applies only when the major appliance is used in the country in which it was purchased. Proof of original purchase date is required to obtain service under this limited warranty. iTEMS EXCLUDED FROM WARRANTY This limited warranty does not cover: 1. Replacement parts or repair labor if this major appliance is used for other than normal, single-family household use or when it is used in a manner that is inconsistent to published user or operator instructions and/or installation instructions. [. . . ]