User manual WHIRLPOOL XHP1550WL INSTALLATION

[. . . ] IMPORTANT: If your washer and dryer are already installed, they must be uninstalled. If you need to uninstall your washer or dryer, see your Installation Instructions that came with your model for tools required. Excessive Weight Hazard Use two or more people to move and uninstall dryer. Protect the floor with a large piece of cardboard cut from the pedestal carton. [. . . ] 5 cm) not under the dryer) so that the cardboard is 15" under the entire lower (38. Excessive Weight Hazard Use two or more people to move washer or dryer. Cut the packaging as follows: Washer: Cut plastic film along dotted cut line around the base. A Dryer: Cut carton around top and down corners along dotted cut lines. NOTE: When laying the washer on its back, hold the bottom cap down on the floor. When laying the dryer on its back, the floor and dryer back are protected by pieces of the carton. Excessive Weight Hazard Use two or more people to move and install pedestal. This package contains 4, #12 x 5/8" hex head sheet metal screws used in step 5 and divider pack. Using 1/4" nut driver, remove the hex-head screws from both drawer slides and save screws. Partially install 2 of the #12 x 5/8" hex head sheet metal screws in the lower holes. Leave a space of about 3/8" (1 cm) between the screw head and the bottom of the washer or dryer. Tip the pedestal on its back and move it against the washer or dryer bottom. Align the sides of the pedestal so that they are even with the sides of the washer or dryer. Reach inside the pedestal drawer opening and securely tighten all 4 pedestal screws. Follow the Installation Instructions that came with your model to finish installing or reinstalling your washer or dryer (hoses, vents, etc. NOTE: Make sure all 4 pedestal feet are in solid contact with the floor. Reach inside the pedestal and use a 1/4" hex-head ratchet or open-end wrench to adjust the feet up or down as needed to level the washer or dryer. The washer or dryer should not move front to back, side to side, or diagonally when pushed on its top edges. [. . . ] Damage resulting from accident, alteration, misuse, abuse, fire, flood, acts of God, improper installation, installation not in accordance with electrical or plumbing codes, or use of products not approved by Whirlpool. Replacement parts or repair labor costs for units operated outside the United States or Canada. Repairs to parts or systems resulting from unauthorized modifications made to the appliance. The removal and reinstallation of your appliance if it is installed in an inaccessible location or is not installed in accordance with published installation instructions. [. . . ]