User manual XEROX 4127 ENTERPRISE

[. . . ] Version 3. 1 September 2010 Xerox® 4112TM/4127TM Enterprise Printing Systems User Guide © 2010 Xerox Corporation. Xerox, the sphere of connectivity design, and Xerox 4112/4127 Enterprise Printing Systems, are trademarks of Xerox Corporation in the United States and/or other countries. Microsoft, MS-DOS, Windows, Microsoft Network, and Windows Server are either trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. Novell, NetWare, IntranetWare and NDS are registered trademarks of Novell, Inc. Adobe, Acrobat, PostScript, PostScript3, and PostScript Logo are trademarks of Adobe Systems Incorporated. [. . . ] Cause: Detected a fatal error by the FreeFlow Print Services Controller. Remedy: Power on/off both the FreeFlow Print Services Controller and the printer. Remedy: Turn off the power, wait until the Control Panel display goes dark and then turn on power again. Switch off the machine immediately, wait for the Control Panel display to go dark and contact the Customer Support Center. Cause: An auto-recoverable internal error occurred and the machine restarted automatically. If the error persists, call contact the Customer Support Center. Cause and Remedy 127-213 P, O 127-220 P, O 127-221 P, O 127-311 P, O A malfunction occurred. (xxx-yyy) P, O P, O Xerox 4112/4127 EPS User Guide 7-21 Problem Solving Paper Jams Review the following list to address paper jams: · · · · · · · When paper jams inside the machine, the machine stops and an alarm sounds. Follow the instructions displayed on the controller to remove the jammed paper. If a piece of jammed paper remains inside the machine, the paper jam message will remain on the display. When the power is turned off, all information stored to the machine's memory will be erased. After clearing a paper jam, printing is automatically resumed from the state before the paper jam occurred. WARNING When removing jammed paper, make sure that no pieces of jammed paper are left in the machine. If a piece of paper is stuck in a hidden area or paper is wrapped around the fuser unit or rollers, do not remove it forcefully. Switch off the machine immediately and contact the Customer Support Center. Paper Jams in Trays 1-4 Tip Always ensure that all paper jams, including any small ripped pieces of paper, are cleared before proceeding with your copy/print jobs. Pull out the tray where the paper jam occurred. Note To avoid tearing paper, review where the paper jam occurred before pulling out a tray. Torn paper remaining inside the machine can cause machine malfunction. 7-22 Xerox 4112/4127 EPS User Guide Problem Solving 2. Remove the jammed paper and any torn pieces. 3. Push the tray in gently until it comes to a stop. Paper Jams in Transport Unit 4 Tip Always ensure that all paper jams, including any small ripped pieces of paper, are cleared before proceeding with your copy/print jobs. Make sure that the machine has stopped printing before opening the front cover. 2. Pull out Tray 1. 3. Pull out Transport Unit 4. Tray 2 will come out as you pull out Transport Unit 4. Xerox 4112/4127 EPS User Guide 7-23 Problem Solving 4. Lift up lever 4a and then remove the jammed paper. Note If paper is torn, check inside the machine and remove it. The machine will not operate if the front cover is open even slightly. Paper Jams in Duplex Module 3 Tip Always ensure that all paper jams, including any small ripped pieces of paper, are cleared before proceeding with your copy/print jobs. Make sure that the machine has stopped printing before opening the front cover. 2. Pull out Duplex Module 3. 7-24 Xerox 4112/4127 EPS User Guide Problem Solving 3. Move the release lever 3a to remove the jammed paper. Note If paper is torn, check inside the machine and remove it. Move lever 3b to the right and then remove the jammed paper. Note If paper is torn, check inside the machine and remove it. The machine will not operate if the front cover is open even slightly. Xerox 4112/4127 EPS User Guide 7-25 Problem Solving Paper Jams in Tray 5 (Bypass) Tip Always ensure that all paper jams, including any small ripped pieces of paper, are cleared before proceeding with your copy/print jobs. When optional high capacity feeder tray is not installed, open the top cover of paper Tray 5 (Bypass). 2. Remove the jammed paper and all paper loaded in paper Tray 5 (Bypass). Note If paper is torn, check inside the machine and remove it. [. . . ] 2X scaling is a PCL image quality control that scales the patterns by a factor of two. This process works well for printing user-defined patterns designed for 300 dpi. A common image format developed by Aldus and Microsoft for scanned color and black and white images. It is a versatile, reliable, and widely supported bitmap format designed for exchanging digital information. [. . . ]