User manual XEROX DOCUMENT CENTRE 555 QUICK REFERENCE GUIDE

[. . . ] If the inside of the Document Glass Cover becomes dirty, the document size may not be detectable by the Scanner. 5. Moisten another clean, soft cloth with water and wipe the white area under the Document Glass Cover. Wipe dry with a clean, dry, soft cloth. 301146a 25-2 Xerox DocuColor 2006 Cleaning procedures 25. Maintenance Cleaning the Document Feeder Document jams can be created by dirt on the feed rollers or the feed belt of the Document Feeder. [. . . ] Always pull it evenly and firmly toward the right-hand side of the Scanner. When the visible area is clean, grasp the top and bottom edges of the feed belt and carefully pull it in the right-hand direction. 0301258A - O L W b. Repeat step 3 until the entire belt is clean. Xerox DocuColor 2006 25-3 25. Open the jam access cover. 301270a 6. Clean the feed rollers as shown. 301259a 7. Close the access cover. 25-4 Xerox DocuColor 2006 Replacing the Dry Ink Cartridges 25. Maintenance Replacing the Dry Ink Cartridges Use this procedure when you are referred here from the Problem Solving section, or when a message to install a Dry Ink Cartridge is displayed on the Control Panel. Open the Printer Front Cover. 0 301034B-WOL 2. If the cartridge to be replace is not visible in the opening perform the following steps: a. Press the Anti-rotation button. 0 301027C-WOL Xerox DocuColor 2006 25-5 25. Maintenance Replacing the Dry Ink Cartridges b. Turn the knob in the direction of the arrow until it stops. 0 301028C-WOL c. 3. Repeat the steps until the desired cartridge is visible in the opening. With the desired cartridge visible in the opening, turn the cartridge in the direction of the arrow until the dot is aligned with the Unlock symbol. 301118b 4. Pull the Dry Ink Cartridge out of the Printer and recycle according to the instructions included in the box. WARNING DO NOT attempt to use old cartridges, as they could cause print quality problems. Dry Ink is flammable and could explode, causing burns and other injuries. 25-6 Xerox DocuColor 2006 Replacing the Dry Ink Cartridges 25. Rotate lever B in the direction of the arrow until the dot is aligned with the Locked symbol. B 301038b If lever B will not move to the Locked position, ensure that the cartridge is all the way into the machine. 25-12 Xerox DocuColor 2006 Replacing the Copy/Print Cartridge 25. Rotate lever A in the direction of the arrow until the dot is aligned with the Locked symbol. A 301039b 13. Close the Printer Front Cover and switch on the DocuColor 2006 power. 301077b Xerox DocuColor 2006 25-13 25. Maintenance Replacing the Copy/Print Cartridge 25-14 Xerox DocuColor 2006 Replacing the Copy/Print Cartridge 25. Maintenance Replacing the Dry Ink Waste Container Perform this procedure when the message Waste Container Full is displayed on the Printer Control Panel. Remove a new Dry Ink Waste Container from the box, and save the box. 0301122A- O L W 2. Open the Printer Front Cover. 0 301034B-WOL 3. 4. Grasp the Waste Container handle, and pinch and hold the lever as shown below. Keeping the container level, pull it out of the Printer. 0301123A- O L W Xerox DocuColor 2006 25-15 25. Maintenance Replacing the Copy/Print Cartridge 5. Place the used container in the box. WARNING DO NOT dispose of used Waste Containers in an open flame. Push the new Waste Container into the Printer until it clicks into place. 7. Close the Front Cover. 301077b 25-16 Xerox DocuColor 2006 Storing the supplies 25. [. . . ] Maintenance Storing the supplies Dry Ink Cartridges · Store the Dry Ink Cartridges away from direct sunlight in the following environment: · · · · · Temperature = 3 to 35° Celsius Humidity = 15 to 80% relative humidity, with no condensation Avoid hot and humid locations Avoid magnetic fields, such as computer screens and disk drives Keep out of the reach of children Handling precautions WARNING Never dispose of the used Dry Ink cartridges in an open flame. · · · · · · Do not attempt to reuse the Dry Ink Cartridges. Wash immediately with cold water if Dry Ink comes in contact with your skin. If moving Dry Ink from a cold area to a warm area, allow at least one hour for the cartridge temperature to equalize. [. . . ]