User manual ZALMAN NBF47

[. . . ] Features 1) The ZM-NBF47 does not need electrical power, for it is a fanless Northbridge cooler that operates without noise or vibration. [. . . ] If any problem is found, contact your place of purchase to obtain a replacement/refund. 2) Do not use the ZM-NBF47 if there are no mounting holes or loops present around the Northbridge chipset. 3) If the enclosed Push Pins (hole diameter: 3mm) do not fit, then use the Push Pins already installed on the motherboard instead. 4) Do not use the ZM-NBF47 if it interferes with any component of the motherboard. In case of contact, flush the contacted area with water and get medical attention if irritation persists. is not responsible for any damages due to external causes, including but not limited to, improper use, problems with electrical power, accident, neglect, alteration, repair, improper installation, and improper testing. 6. Installation Procedure Push Pin Spring Nut Link Assembly Bolt Link Connect the Bolt and the Nut through the Link then assemble the Push Pin and the Spring together on the Link to form the Link Assembly. The end of the Spring with the smaller diameter should be directing towards the head of the Push Pin as illustrated in the picture. Nut Link Link Assembly Adjust the Nut of the Link Assembly to insert the Link Assembly into the groove of the ZM-NBF47 in the direction of the arrow as shown in the picture. Mounting Hole Align the Push Pins with the motherboard's mounting holes, then fasten the bolts tightly with a screw driver. Remove any dust or residue on the surface of the Northbridge chipset, and apply an even layer of the enclosed thermal grease on the surface of the chipset that makes contact with the heatsink. [. . . ] Be sure to hook the Clip into the middle of the loop. www. zalman. co. kr www. zalmanusa. com [. . . ]