User manual ZANUSSI FLS624C
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual ZANUSSI FLS624C. We hope that this ZANUSSI FLS624C user guide will be useful to you.
You may also download the following manuals related to this product:
ZANUSSI FLS624C (713 ko)
ZANUSSI FLS624C (735 ko)
ZANUSSI FLS624C (738 ko)
ZANUSSI FLS624C (773 ko)
ZANUSSI FLS624C (646 ko)
ZANUSSI FLS624C (199 ko)
Manual abstract: user guide ZANUSSI FLS624C
Detailed instructions for use are in the User's Guide.
[. . . ] Before washing ensure that all pockets are empty and buttons and zips are fastened. Any objects such as coins, safety pins, nails, screws, stones or any other hard, sharp material can cause extensive damage and must not be placed into the appliance nor left in the pockets. Avoid washing frayed or torn articles and treat stains such as paint, ink, rust, and grease before washing. Garments which have been in contact with volatile petroleum products should not be machine washed. [. . . ] 5
22
Levelling
Level the appliance by loosening or tightening the feet. Once in the right position fix the feet by pushing the nuts against the base of the case. Accurate levelling will prevent vibration, noise and displacement of the appliance during operation. If posible always place the appliance on a solid floor.
P0254
P0509
Hydraulic connection
There should be a COLD WATER tap near the washing machine with a screwing on connection pipe of 3/4 gas for the water supply, a sink, a wash basin or a drainage system in the wall. If not, run off a reasonable amount of water to flush out any debris that may have collected in the pipes. Place the enclosed rubber joint, delivered in a plastic bag together with the appliance (A), at the very end of the inlet hose and carefully screw the pipe to the tap taking care not to damage the screwdrive and fix the nut well on to the end in order to avoid leaking. If necessary turn the hose adequately by unscrewing the nut at the rear of the appliance. (Open the tap and asure that it does not leak and close it again. ) Place the discharging hose in a washbasin or sink with the aid of the bent piece delivered separately. The bent piece has to be entered into the tube's mouth in order to assure the support. Aforesaid piece allows the hose to be fixed to the wall by means of an opening on the upper part and that way the hose does not move and its falling is avoided.
P0021
A
AL013
P0022
23
IMPORTANT: The distance from the floor to the highest part of the hose should be between 60 to 90 cm. Should a prolongation of the discharging hose be unavoidable this must never surpass 1. 5 m and must be of the same diameter as the original hose. Select the temperature
Tur n the dial clockwise to the desired temperature.
AL022
5. Select the program
Turn the dial clockwise until the marker reaches the desired program.
27
6. Start
Before pulling the On/off knob check if: s The door is properly closed.
s s s s
The appliance is plugged in. The drain hose is adequately positioned.
2
Pull the program dial up to you till it klicks. Stop
P0215
ALO26
The washing machine stops automatically once the cycle is finished, the pilot goes out. Open the door 2 to 3 minutes after the end of the program to give the safety device time to unlock. Leave the door ajar for a few minutes for the steam to get out.
IMPORTANT REMARK: This appliance is provided with a security device to avoid opening during the cycles. Open it only when absolutely necessary and wait 2 to 3 minutes after you have stopped the machine to give the safety device time to unlock.
28
PROGRAMS
Programs for cotton and linen
Recommended load: max. 4, 5 kg.
PROGRAM DEGREE OF SOIL heavy soil COMPARTMENTS TO USE MAXIMUN POSITION WATER PROGRAM TEMP. DESCRIPTION Prewash Wash at 90°C 4 rinses Spin Wash at 90°C 4 rinses Spin Wash at 60°C 4 rinses Spin Wash at 40°C 4 rinses Spin 4 rinses Spin Load additif 1 rinse Spin Drain water Spin 2, 5 min.
WHITES with prewash WHITES without prewash FAST COLOURS NON-FAST COLOURS
90 90 60 40
1 2 2(·) 3 4 5 6
normal soil
normal soil
normal soil
RINSES
ADDITIVES SOFTENER
SPIN
(·) This 60° programme is the reference programme for the Energy label according to the article 2, paragraph 1 of the EEC. Directive 92/75.
29
Programs for synthetics, mixed and wool
Recommended load: max. [. . . ] This way you make sure now water at all remains in the appliance which could freeze and thus damage it and its surroundings. When you need to start the machine up again, make sure that the room temperature is above 0°C.
33
Cleaning the filters
The drain filter
A clean filter is important for correct functioning of the washing machine, and it should therefore be cleaned regularly. Small objects left in the pockets and yarn ist retained here.
AL012
AL010
Unscrew the filter completely turning it anticlockwise. Attention Never remove the unloading filter while the washing machine is operating. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE ZANUSSI FLS624C
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual ZANUSSI FLS624C will begin.